Mould

Before production, we should check if the mould has any defect and then brush the grease on the back of the upper mould. (Function of grease: make it easier to clean the spilled injecting materials.

Spraying

Spray gel-coat on the mould. After spraying gel-coat, we should check whether the gel-coat was damaged or not and if thickness of gel-coat is qualified. Then put the tray into the industrial oven to dry the gel-coat.

Injecting

After drying the gel-coat, combine the mould and inject resin material into the mould. Then wait for the material to be congealed.

Trimming

When the shower tray has been shaped we can do the cutting. Place the tray horizontally and then cut the leftover material off by cutting machine.

Polishing

The shower tray will be sent to the area for polishing after cutting. Brush wax on the polishing machine and then polish the surface of the tray evenly.

Inspection

Our strict QC department checks the shower tray if deformed or not. If it’s qualified, then clean the surface and the back side of the tray.

Packaging

The shower tray will be delivered to packaging department for packing after it is checked qualified completely.